Removing The Front Wheel - Husqvarna TE 630 2011 I.E. Manual De Uso

REMOVING THE FRONT WHEEL

Set a stand or a block under the engine and see that the
front wheel is lifted from the ground.
SMS: remove the two screws (A) and the brake calliper.
Loosen the bolts (1) holding the wheel axle (2) to the
front fork mounts. Hold the head of the wheel axle in
place, and unscrew the bolt (3) on the opposite side;
draw the wheel axle out.
EN - 38
Note *:
Do not operate the front brake lever when the wheel has
been removed; this causes the calliper pistons to move
outwards. After removal, lay down the wheel with brake
disc on top.
2
A
1
1
3