Publicidad
Idiomas disponibles
Idiomas disponibles
3
ATTACHMENT OF THE ELEMENTS
1 Choose a location for the control panel, taking as a
reference the figure shown in "Elements of the
complete installation" on page 39.
The height from the ground must be
sufficient as to be out of the reach of children.
The attachment surface must resist the
weight of the control panel.
2 Make two holes and attach the panel with
appropriate screws.
4
ELECTRICAL CONNECTIONS
Complete the installation in line with the low voltage regulations and applicable rules.
Use cables with sufficient section, and always earthed.
Check the manufacturer's instructions for all the elements installed.
Power supply and motor connections
C: capacitor
T: earth connection
3 Attach the other elements of the installation in line
with the corresponding instructions.
4 Position the ducts for the cable, securing them firmly
using appropriate means.
If buttons are installed to operate the facility,
we recommend installing them out of the reach
of children (minimum recommended height
1.6 m).
Motor connections:
1
common
2
rotation 1
3
rotation 2
Control panel AEP10-009/ AEP10TOP9
SET-UP
45
Publicidad
