Publicidad
Idiomas disponibles
Idiomas disponibles
PROGRAMMING AND STARTING UP
1
CONTROLS AND COMMANDS
On
Pedestrian
SW2 functions
Functions during recording (DIP1=ON)
DIP2=ON: total opening travel recording (see page 50)
DIP3=ON: pedestrian opening travel recording (see
page 51)
DIP4=ON: pedestrian opening radio code recording
(see page 49)
DIP6=ON: total opening radio code recording (see
page 49)
Functions during use (DIP1=OFF)
DIP2: operation warning
DIP2=ON: the light lights up and the operation
begins after a 3 second warning.
DIP2=OFF: the light lights up and the operation
begins immediately.
DIP3: step-by-step or community opening mode
DIP3=ON: step-by-step mode (the panel obeys
the command during opening).
DIP3=OFF: community mode (the panel does
not obey the command during opening).
48
Installation manual
Close Open
SW1 General power switch
SW2 Programming micro-switches
ST1 Total closing and opening operations mini-button
ST2 Opening and pedestrian closing operations mini-
button (TOP9 only)
PUL1Close mini-button
PUL2Open mini-button
T.LG Garage light duration regulation power meter
(TOP9 only
T.E. Open gate waiting time regulation power meter
(only works in automatic mode)
P.M. Motor torque limit regulation power meter
DIP4: automatic or semiautomatic closing mode
(only with DIP10=OFF)
DIP4=ON: Automatic mode (the gate closes
automatically after the waiting time).
DIP4=OFF: Semiautomatic mode (the gate
only closes when receiving the command).
Waiting time is adjusted by way of T.LG.
DIP5: back pulse/close pulse
DIP5=ON: back pulse enabled. Should slow
down be selected, a close pulse is also made.
DIP5=OFF: close and back pulse disabled.
DIP6: automatic closing mode optional (only with
DIP4=ON)
DIP6=ON: during waiting, the gate obeys the
control (this can be closed using the control before
waiting time finishes).
DIP6=OFF: the gate cannot be closed until the
waiting time finishes.
DIP7: maintain hydraulic pressure (only for
hydraulic operators)
DIP7=ON: maintain hydraulic pressure activated.
A close pulse is sent every half an hour as of the last
operation.
DIP7=OFF: maintain hydraulic pressure disabled.
DIP8: slow down function
DIP8=ON: the motors reduce their speed before
reaching the stopper.
DIP8=OFF: the motors reach the stopper at the
maximum programmed speed.
DIP9: without function, place in OFF
Publicidad
