Erreka AEP10-009 Manual Del Instalador página 57

MAINTENANCE AND DIAGNOSIS OF FAILURES
1
MAINTENANCE

Before carrying out
operation, disconnect the device from the
power supply.
1 Frequently check the installation in order to discover
any imbalance or signs of deterioration or wear. Do
not use the device if any repair or adjustment is
necessary.
2
FAILURE DIAGNOSIS
Diagnosis LEDs and cut-outs
SW1 General power switch
F1 Motor cut-out (2.5A)
F2 Electronic cut-out (0.5A)
F3 Peripheral cut-out (315mA)
DL1 Gate on standby after opening
DL2 Electronic circuit power supply
DL3 Operation recording
DL4 Opening
DL5 Close
DL6 Interior photocell (TOP9 only)
DL7 Opening end of travel
any maintenance 2 Check that the controls and photocells, as well as
their installation, have not suffered any damage
from the weather or external agents.
DL8 Closing end of travel
DL9 Exterior photocell
DL10 ST2 Pedestrian opening key (TOP9 only)
DL11 ST1 Total opening key
DL12 Receiving radio card signal
DL13 Garage light on
DL14 Power supply 230Vac
DL15 Electrolock relay activated
DL16 Electrolock activated
DL17 Triac M1 operating
Control panel AEP10-009/ AEP10TOP9
English
53