cecotec EnergySilence Aero 3600 Invisible Natural Design Manual De Instrucciones página 51

downwards, bringing cold air to the bottom of the room.
Natural breeze
Activate this mode by pressing button 6. The fan will progressively vary the power level in
cycles, providing a feeling of fresh air.
Pairing between remote control and receiver
To operate the remote control, reconnect the mains power supply from the electrical
switchboard in the house.
1. Press the power button for 5 seconds and then you will hear a beep, which means that the
pairing has been completed successfully and you can use the remote control normally.
NOTE: be sure to press the power button for 30 seconds before pairing the remote control,
otherwise you will not be able to pair it.
2. If you notice that the transmitter does not control the receiver, check that the batteries are
inserted correctly and that they are not dead.
3. This may also be due to the proximity of similar products that also operate with a remote
control, which, if they use the same frequency, could cause interference.
4. If the batteries in the remote control are dead, replace them so that you can continue to
use it normally.
5. Remove the batteries from the remote control if you are not going to use it for a long period
of time.
6. Make sure that the earth wire is properly connected.
7. When positioning the fan, make sure that no wires are pinched. If this happens, a short-
circuit may occur.
Reminder:
- The receiver must be correctly installed in the fan mounting bracket.
- Remove the batteries from the remote control if you are not going to use it for a long period
of time.
- The isolation switch must be switched on.
- If the power is cut off (e.g. due to a blackout) the light will go out. When the power is
restored, the light will switch on again.
Receiver protection functions
- The DC motor has a built-in safety feature against blade or motor obstruction during
operation.
- During operation: if something obstructs the fan blades or motor, the motor will keep
trying to run and then stop operation after about 30 seconds of interruption. Remove
obstructions and restart the motor. To restart it: switch the fan off from the remote control
ENERGYSILENCE AERO 3600 INVISIBLE NATURAL DESIGN
ENGLISH
51