cecotec EnergySilence Aero 3600 Invisible Natural Design Manual De Instrucciones página 52

ENGLISH
and then switch it on again.
- The device will limit the maximum current output from the receiver/drive if the fan load
has increased abnormally.
Tips
1. If your fan runs automatically when you switch it on for the first time after installation, it
has memorised the previous factory setting.
2. If the fan or light does not work, reset the fan. To do this, turn it off for at least 5 seconds
and then turn it on again.
3. It is not possible to control more than one fan in the same room if they share the same
power supply.
4. If you want to separately control more than one fan in the same room, you must use
separate power supplies.
5. When the fan is switched on and starts running in either direction (clockwise or
counterclockwise), it will stop and change direction several times. This is normal. The fan
will take some time to perform the selected function and to start up regularly.
5. CLEANING AND MAINTENANCE
1. Clean your fan periodically.
2. To clean, only use a soft brush or lint-free cloth to avoid scratching the finish.
3. Abrasive cleaning agents are not necessary and should be avoided in order not to damage
the finish.
Warning. do not use solvents to clean the fan. Doing so may result in electric shock.
RECOMMENDATION: periodically check that the blades are securely fastened to the motor with
the screws.
52 ENERGYSILENCE AERO 3600 INVISIBLE NATURAL DESIGN