Publicidad
Idiomas disponibles
Idiomas disponibles
hole. Tighten with an 18 mm wrench applying torque
within the range of 15 - 22 ft-lbs (20 - 30 N·m).
Insert clevis pins and R pins into the top hole to
secure the top roll bar in the raised position.
3. At the middle and bottom sections of the roll bar,
connect the corresponding wire connectors.
4. Make sure all nuts and bolts are torques to the
mentioned values above.
4.2
INSTALL THE SEAT
1. Position the seat assembly over the seat panel and
align holes.
2. Install two bolts on the front of the seat and tighten
securely with a T40 wrench applying torque within
the range of 14 - 18 ft-lbs (20 - 25 N·m).
English
3. Pull the seat adjustment lever to move the seat
forward and expose the two mounting holes in the
back. Install the two bolts and tighten securely.
4. Connect the wire connector to the seat plug located
behind the seat. Ensure the plugs are securely
attached.
13
EN
Publicidad
