Publicidad
Idiomas disponibles
Idiomas disponibles
The terms "device" or "product" are used in the warnings and instructions to refer to:
Table milling machine
2.1.
Electrical safety
a)
The plug must fit the socket. Do not modify the plug in any way. Using original plugs and matching
sockets reduces the risk of electric shock.
b)
Avoid touching earthed elements such as pipes, heaters, boilers and refrigerators. There is an
increased risk of electric shock if the earthed device is exposed to rain, comes into direct contact with
a wet surface or is operating in a damp environment. Water getting into the device increases the risk
of damage to the device and of electric shock.
c)
Do not touch the device with wet or damp hands.
d)
Use the cable only for its designated use. Never use it to carry the device or to pull the plug out of a
socket. Keep the cable away from heat sources, oil, sharp edges or moving parts. Damaged or tangled
cables increase the risk of electric shock.
e)
Do not use the device if the power cord is damaged or shows obvious signs of wear. A damaged power
cord should be replaced by a qualified electrician or the manufacturer's service centre.
f)
To avoid electric shock, do not immerse the cord, plug or device in water or other liquids. Do not use
the device on wet surfaces.
g)
Do not use in very humid environments or in the direct vicinity of water tanks.
h)
Prevent the device from getting wet. Risk of electric shock!
i)
Before the first use, please check whether the main voltage type and current comply with the
indicated data on the type plate.
2.2.
Safety in the workplace
a) Make sure the workplace is clean and well lit. A messy or poorly lit workplace may lead to accidents.
Try to think ahead, observe what is going on and use common sense when working with the device.
b) Do not use the device in a potentially explosive environment, for example in the presence of flammable
liquids, gases or dust. The device generates sparks which may ignite dust or fumes.
c)
If you discover damage or irregular operation, immediately switch the device off and report it to a
supervisor without delay.
d) If there are any doubts as to the correct operation of the device, contact the manufacturer's support
service.
e) Only the manufacturer's service point may repair the device. Do not attempt any repairs
independently!
f)
In case of fire, use a powder or carbon dioxide (CO2 ) fire extinguisher (one intended for use on live
electrical devices) to put it out.
g) Children or unauthorised persons are forbidden to enter a work station. A distraction may result in loss
of control over the device.
h) Use the device in a well-ventilated space.
i)
The device produces dust and debris during operation. It is important to protect bystanders from their
harmful effects.
j)
Regularly inspect the condition of the safety labels. If the labels are illegible, they must be replaced.
k) Please keep this manual available for future reference. If this device is passed on to a third party, the
manual must be passed on with it.
l)
Keep packaging elements and small assembly parts in a place not available to children.
m) Keep the device away from children and animals.
n) If this device is used together with another equipment, the remaining instructions for use shall also be
followed.
Remember! When using the device, protect children and other bystanders.
2.3.
Personal safety
EN
Publicidad
