Publicidad
Idiomas disponibles
Idiomas disponibles
EN
2 Plastic cap nuts M6
2 Washers 6mm
Mounting the moulding fence, Fig. 2–5
The moulding fence has been shipped in the carton box disassembled. Before starting work, it must
be assembled and fitted onto the working table.
Step 1: Assembly of part A and B
Push the mounting (B) onto the base holder (A. 1) in the groove provided (see Fig. 4). Now insert a
carriage bolt M6 x 25 into the hole and screw on a plastic cap nut with a washer.
Step 2: Fitting the stop bars C
Insert two carriage bolts into the attachment holes and screw them on finger tight with a washer and
a plastic cap nut. Then, with the groove, push the fence onto the carriage bolt caps. Now tighten
both plastic cap nuts. Carry out the same process on the other side of the fence. Make sure you
attach the fences (C) in the correct direction. Check that the fences (C) and the base holder and
bracket (A. 1 + A. 2) are at the same height.
Step 3: Fitting pressure part D
Attach the pressure bar (D) to the fence with 2 carriage bolts, 2 washers and 2 plastic cap nuts.
Publicidad
