MSW Motor Technics MSW-WOBD-1500Y Manual De Instrucciones página 47

EN
Installing and adjusting the pressure limits, Fig. 20
The pressure limits (5) are designed so that the work piece is held on the spot and setback is avoided.
• Drive milling cutter to the lowest position
• Insert the workpiece to be machined and press the pressure bar onto the workpiece with light
pressure.
• Remove workpiece.
• Set the milling cutter to the desired height (see: Setting the working depth).
Adjust the Cross-cutting jig, Fig. 21
• Slide horizontal along the table the cross-cutting jig (8) in order to implement clean up error and
mitre cuts.
• In order to stop the jig at the desired angle, loosen the locking knob of the cross-cutting jig and turn
this to the desired angle.
Tighten the locking knob of the jig (8) again.
• Always make a sample cut in a piece of waste material in order to guarantee that the attitudes are
correct.