MSW Motor Technics MSW-WOBD-1500Y Manual De Instrucciones página 37

EN
Fixings for pressure device, Fig. 6.1 + 6.2
F - Pressure frame 2x
G - Square mounting plate 2x
H - Square bolt 2x
I - Clamp for square bolt 2x
Assembling the pressure device:
Insert the 2 square bolts (H) in the 2 square tubes provided and secure them with the 2 Allen screws.
Attach the 2 clamps (I) on the 2 square bolts (H) using the 2 plastic cap screws. Then push the 2
square mounting plates (G) through the 2 openings of the 2 clamps (I). Finally, attach the pressure
frames (F) to the square mounting plates using the 4 carriage bolts, the 4 washers and the 4 plastic
nuts.