Publicidad
Idiomas disponibles
Idiomas disponibles
1- Crank
2- Screw shaft
3- Press cage
4- Pressure adjustment bolt
5- Press cover
6- Fuel bottle
Components of the device
This machine consists of frame, press part, driver part, and heating part, etc. Because of environmental
protection and recycling, material feeding/collecting equipment can be replaced with a drink bottle, which
buyer prepares.
3.2.
Preparation for use
Assembly
Before operation please fix the frame and make sure the crank can be turned freely.
Lubricate the washer with edible oil and insert it on the screw shaft from the small end.
Insert screw shaft in the press cage.
Screw on press cage cap and screw on pressure adjustment bolt.
Attach the crank arm to the screw shaft and tighten the bolt.
Fill 80% fuel into the lamp bottle (kerosene or alcohol), pass a 15cm wick through the washer.
Leave 0.5cm of wick outside and put the longer end in the fuel bottle—place the washer at the bottle mouth.
Place the lamp under the press cage. Secure the light with a rubber band.
Accessories
The nuts are used to protect the table after mounting the clamping jaw.
EN
Publicidad
