Fronius STRING CONTROL 125/25 Manual De Instrucciones página 16

Fitting wall
bracket
(continued)
Fig. 9 Parts for wall bracket
Fig. 10 Fitting the wall bracket
1.
2.
3.
(3)
(2x)
(4) (5)
(4)
NOTE! As the choice of dowels and screws will depend on the subsurface,
these are not included.
Fit part (1) of the wall bracket to a firm surface using suitable screws (4) and dowels
(5)
CAUTION! Risk of injury and damage from falling device if the Fronius String
Control 125/25 is not secured with part (2) of the wall bracket. Attach Fronius
String Control 125/25 to part (1) of the wall bracket and secure using part (2)
of the wall bracket.
Attach Fronius String Control 125/25 to part (1) of the wall bracket
Fit part (2) of the wall bracket using suitable screws and dowels
The following illustration shows both parts
(1) and (2) of the wall bracket. Both parts
are enclosed with the Fronius String
Control 125/25.
(1)
To fit part (2), proceed as follows:
- Loosen screws (3) on the underside
of the Fronius String Control 125/25
- Fit part (2) using screws (3)
(2)
(1)
(5)
Fig. 11 Fitted wall bracket
8