geberit MAPRESS Manual Del Usuario página 57

CAUTION
Danger of cutting due to sharp edges on the Geberit
pressfitting
Defective Geberit pressing collars can cause sharp
edges to form on the Geberit pressfitting.
▶ Only use pressing collars that are in perfect working
order and are maintained.
▶ Check the pressfitting for sharp edges after the
pressing procedure and replace the pressing collar if
necessary or have it tested by an authorised repair
shop.
11
Open the Geberit pressing collar and detach it.
If a press connection has not been completely pressed – in
the event of a power cut, for example – it must be pressed
again. The Geberit pressing jaw and the pressing collar
must not be removed or rotated during the process.
Corrective pressing is performed in the same way as a
normal pressing operation. Depending on the state of the
preliminary pressing, there may be considerable idle stroke
before the pressing tool engages during corrective pressing.
36028804990855691 © 12-2023
970.496.00.0(01)
EN
57