Babyauto Winy Savile V3 Manual De Uso página 29

3. Make sure the lap section of the harness is positioned as low as
possible, surrounding your child's hips and not his stomach.
4. A harness that is not properly tightened can be dangerous. Check
the harness adjustment and tighten whenever you put your child in
the child safety seat.
Loosening the harness
1. The harness is loosened by pressing the adjustment button of the
harness (under the seat cover) at the front of the seat. (6.11)
2. Press the harness adjustment button
while holding both harness straps with your other hand.
3. Pull the harness straps towards you to loosen the harness.
4. Be careful when adjusting the harness strap not to trap the harness
adjustment strap when you press the button down.
7. SEAT AND HARNESS REMOVAL.
Remove the seat harness
1. From the back of the seat, unhook the
connector tapes and detach the harness from the
connector of harness (7.1, 7.2, 7.3 y 7.4).
2. Pull the loose strap towards the front of the seat to detach
completely from the seat (7.5 y 7.6).
3. Remove the harness pads
Remove the cover buckle protector and the lower harness
1. Unfast the harness pressing
(7.8).
2. Remove the insert tongues from harness straps (7.9).
3. Lift the seat cover, and then unthread the buckle through the
cover´s buckle slot (7.10).
4. Place the buckle on the notch at the right side of the seat base, and
place the harness straps under the seat cover (7.11)
Group 0+/1/2
C out of the harness strap (7.7).
G button on the buckle downwards.
J down with one hand
S harness protector
O
www.babyauto.com
metal
29