Publicidad
Lead the pre-embedded Ethernet cable to the dock and make sure to reserve the proper length for
connection. Cut the corrugated tubing plug at the appropriate position according to the outer diameter of
the Ethernet cable. Lead the Ethernet cable through the corrugated tubing and the corrugated tubing plug in
sequence. Check that the corrugated tubing is in a contracted state as shown in the diagram to ensure that
the Ethernet cable will not be exposed after attaching the Ethernet connector to the dock.
1. Follow the steps below to rebuild the Ethernet connector.
a. Disassemble the original Ethernet connector and loosen the tail nut.
b. Lead the Ethernet cable through the Ethernet connector. Crimp it to the pass through connector
by following the T568B wiring standards. Make sure that the PVC surface of the cable is effectively
inserted into the connector, and that the wire is not exposed. Use a network cable tester to check that
the contact with the Ethernet cable has good contact with the pass through connector and the wiring
sequence meets the requirements. Insert the pass through connector into the outer casing until a click
is heard.
c. Tighten the tail sleeve and the tail nut in sequence.
2. Open the cover of the LAN-IN port and securely connect the Ethernet connector to the LAN-IN port until a
click is heard.
2
1
2
• Make sure the other end of the Ethernet cable is properly and securely connected to the device in the
user computer room.
• Make sure the network is able to access the Internet with an upstream and downstream bandwidth
greater than 10 Mbps. To ensure a better user experience, it is recommended that the bandwidth be
greater than 40 Mbps.
• Make sure to close the LAN-IN port cover when the port is not in use.
• After installation, press the locking tab of the pass through connector using a flathead screwdriver to
remove it from the Ethernet connector, if necessary.
6
1
2
T568B
3
1
Publicidad
