Publicidad
• Refer to the DJI Matrice 3D Series User Guide included in the aircraft packaging for the aircraft
introduction and preparation information.
• The aircraft and the dock require activation before first time use. An internet connection is required
for the remote controller during activation.
• It is recommended to consider whether the planned flight area is near or in a Restricted Zone from
DJI Fly Safe (https://fly-safe.dji.com/). Make sure to apply for a GEO Zone Unlocking License and
import it to the aircraft during installation and configuration.
• Go to the Dock Onsite Debugging in DJI Pilot 2 to re-configure the dock if necessary.
• When transporting the unpacked dock, make sure to remove the aircraft from the dock and transport
them separately.
Connecting the Remote Controller as Controller B
To ensure flight test safety of the dock, the remote controller can be used to take control of the aircraft
manually during flight after connecting to the aircraft as controller B.
1. After disconnecting the USB-C cable, restart DJI Pilot 2, tap Controller A on the home screen, and switch to
Controller B.
2. Power on the aircraft, press and hold the power button on the aircraft for at least five seconds, and wait
for the remote controller to successfully link with the aircraft.
• Make sure to calibrate the aircraft compass before using for the first time. Otherwise, the aircraft
positioning accuracy may be adversely affected.
• Go to the camera view in DJI Pilot 2, tap
sensing system, remote controller, and battery.
Automatic Operation Test
6
To ensure that the dock and aircraft are properly functioning, make sure to create a flight route and plan a
flight task in DJI FlightHub 2. Launch the flight task to allow the dock to perform the automatic operation test
after completing the dock configuration in the app.
Binding the Dock to a Project
1. Use a computer to visit https://fh.dji.com, and log in to DJI FlightHub 2 using a DJI account.
2. Click Project > + in the project list, and then fill in the information to create a project.
3. Click Devices > Dock > Actions
in the drop-down box of the project.
• Click Members to add members and fill in the members' accounts (DJI account), organization names,
and roles.
to set the parameters for the camera, flight controller,
> Edit as shown in the diagram and add the dock to the specified project
11
Publicidad
