Publicidad
Powering on the Dock
Pre-Powering On Checklist
Checklist
Description
Earth Wire
Ethernet Cable
Power Cable
The Dock
The Surrounding
Environment
Powering On and Checking Operation
1. Make sure the upstream main switch in the user distribution box has been turned on. Turn on the surge
protector circuit breaker (A), AC power switch (B), and backup battery switch (C) in the electrical cabinet in
sequence.
2. Within 30 seconds, the electrical cabinet status indicators should display as follows. Otherwise,
troubleshooting is to be performed.
A
B
• Make sure the AC power switch and backup battery switch are both turned on.
The two ends of the earth wire have been properly connected, and the screws have
been tightened securely.
All parts of the Ethernet connector have been tightened securely.
A corrugated tubing plug has been properly used to seal the gap between the
corrugated tubing and the Ethernet connector.
The Ethernet connector has been inserted to the dock securely.
The wire connection test has been performed and the wire sequence is correct.
The insulation layer of the power cable has been properly covered by the tail nut.
All parts of the power connector have been tightened securely.
A corrugated tubing plug has been properly used to seal the gap between the
corrugated tubing and the power connector.
The power connector has been inserted into the dock securely.
The dock has been installed and is stable with a tilt angle of less than 3 degrees.
The inside of the dock is clean and tidy, without any dust or dirt, or items left inside.
The emergency stop button of the dock has been properly pulled out and released.
The landing pad surface is clear of any metal objects.
The area around the dock has been cleared of packaging materials such as cartons,
foam, and plastic.
No obstacles block the dock covers when they are opened.
C
Status Indicators
Normal States
Power
Solid red
Indicator
Solid blue
Backup Battery
Indicator
Blinks blue
slowly
Wired Network
Blinks green
Indicator
quickly
4G Network
Blinks green
Indicator
quickly
Description
AC power supply is normal.
Backup battery is full or is
supplying power to the dock.
Backup battery is charging.
The Ethernet cable is connected
and has data transfer with the
dock.
4G network is connected and has
data transfer with the dock.
9
Publicidad
