Omron MIT Elite Plus Manual De Instrucciones página 28

HEM-7301-ITKE_main.book Page 28 Friday, October 3, 2008 12:42 PM
3.Using the Unit
To Delete All the Values Stored in Memory
You cannot delete individual stored readings, all the readings in the
unit will be deleted.
1.
Press the Memory button
( ) to turn the monitor on.
2.
Press the Memory button
( ) again. While holding the
Memory button (
the O/I Start button down for
approximately 5 seconds
until the digital display
appears as it does in the illustration to the right.
3.
Press the O/I START button to turn the unit off.
If you forget to turn the unit off, it will automatically shut itself off
after two minutes.
Note: If the date and time are reset to a time before the most
recent measurement, the average value will be based on
any measurements taken after the date and time were
reset. However, you can still view the readings stored in
memory.
28
), press