FLAEM AirFeel Manual De Instrucciones De Uso página 21

- Repeat the inhalation and exhalation cycle following the instructions provided by the
medical staff
- End the treatment session if the effort becomes excessive.
Notes for optimal treatment:
Place your free hand against your chest while inhaling and exhaling: when using the devi-
ce correctly, you can feel an unmistakable regular vibration. The intensity of the vibration
varies according to the alignment of the device on the ground: align the device in the
position where the vibration is perceived to be strongest (tilt the device slightly upwards
or downwards).
Therapy in combination with a medical device model RF7-1 or RF7-2
It is feasible both in the case of PEP therapy and O-PEP therapy (for all the instructions
and restrictions on use of the device model RF7-1 or RF7-2, refer to the nebulizer's manual
provided).
USE OF THE DEVICE IN COMBINED MODE WITH MEDICAL DEVICE MODEL
RF7-1 or RF7-2
Having defined the therapy to be applied PEP or O-PEP and
carried out the operations described in the respective pa-
ragraphs "Preparation for the therapy" and "Adjustment of
the expiratory resistance" and "Execution of the treatment"
connect the output of the nebulizer model RF7-1 or RF7- 2
in the valve cap (4) as shown in the figure.
In this mode, the mouthpiece to be used is the one
supplied with the AirFeel device and not the one with the
exhalation valve supplied with the Flaem nebuliser model
RF7-1 or RF7-2. Do not use any masks supplied with the
nebuliser model RF7-1 or RF7-2.
HYGIENIC PREPARATION
Take apart the AirFeel system in its individual parts.
Sanitization
Sanitize the components by choosing one of the methods provided in the table and described
below.
method A: Sanitize the accessories under hot drinking water (about 40°C) with a delicate
dishwashing detergent (non-abrasive).
method B: Sanitize the accessories in the dishwasher with a hot cycle (70°C).
method C: Sanitize the accessories by immersing them in a solution of 50% water and 50% white
vinegar, then rinse thoroughly with hot drinking water (about 40°C).
Disinfection
After having sanitized the components, disinfect them by choosing one of the methods
provided in the table and described below. Each method can be used for a limited number
21