Specifications - 3M Speedglas 9100 MP Manual De Instrucciones

When assembled according to these User Instructions, this headgear meets the high impact requirements of the
ANSI Z87.1 standard for eye and face protection devices, and the requirements of the ANSI Z89.1 (Type I, Class
G) standard for industrial head protection.
Occupational use of these products for eye and face and/or head protection must be in compliance with applicable
health and safety standards. In the US, employers must comply with the OSHA personal protective equipment
(PPE) standard (29 CFR 1910.132) and, as applicable, the eye and face standard (29 CFR 1910.133) and the head
protection standard (29 CFR 1910.135). In Canada, consult the applicable standard(s) for your jurisdiction.

Specifications

NOTE: The 3M™ Speedglas™ Welding Helmets 9100 MP contains no component made from
natural rubber latex.
Table 1. Specifications for 3M™ Speedglas™ Welding Helmets 9100 MP
Technical Data
Approximate Viewing Area
Approximate ADF Battery
Life (min.) (2 x CR-2032)
Solar Assist
Approximate Weight
Dark Shades
Light State
Switching Speed
Special Modes
Sensitivity Modes
TIG Rating
Number of Sensors
Delay (Recovery)
ADF OperatingTemp. Range
Standards Compliance
ADF Warranty
Head sizes
SideWindows
Protection Plates
Flame Resistant Fabric
V-Size ADF
1.8 x 3.7 in.
(45 x 93 mm)
2,800 hours
Yes
41.6 oz. (1178 g)
Shades 5, 8, 9, 10, 11, 12, 13
Shade 3
< 0.1 ms (+23°C)
Grind, Tack, Lock-in
5 levels
> 1 Amp
3 (2 eye-level, 1 center)
Adjustable 40 - 1300 ms (approximate)
23°F to 131°F (-5°C to 55°C)
ANSI Z87.1 & CSA Z94.3
ANSI Z89.1 Type 1 – Class G
3 Years
6 3/8 to 8 (51-64 cm)
Polycarbonate
Polycarbonate
75% FR Cotton, 25% Synthetic Aramide
5
X-Size ADF
2.1 x 4.2 in.
(54 x 107 mm)
2,500 hours
Yes
41.9 oz. (1188 g)
XX-Size ADF
2.8 x 4.2 in.
(72 x 107 mm)
2,000 hours
No
42.9 oz. (1213 g)