Operating Instructions; Unpacking; Assembly - 3M Speedglas 9100 MP Manual De Instrucciones

Additional Technical Information
Airflow range
Noise level
Storage Temperature Range*
*4ºC to 35ºC (40ºF to 95ºF) suggested storage temperature range if product will be stored for an extended period
of time before first use.
NOTE: TWhen the 3M Speedglas 9100MP is used with 3M Speedglas Complete Neck Coverage 27-
0099-87, the welding helmet meets the Assigned Protection Factor (APF) definition of a "welding helmet/
hood" as defined by OSHA in the Respiratory Protection Standard, 29 CFR 1910.134. See Speedglas™
Complete Neck Coverage for 9100 MP Addendum for proper installation and use.
Assigned Protection Factors (APF)
Model Number
9100 MP
9100MP w/ Complete Neck
Coverage 27-0099-87
In Canada, follow CSA Z94.4 or the requirements of the authority having jurisdiction in your region.
1

OPERATING INSTRUCTIONS

Unpacking

Inspect the package contents for shipping damage and ensure all components are present. The product should
be inspected before each use following the procedures in the Inspection section of these User Instructions.

Assembly

3M™ Speedglas™ Welding Helmets 9100 MP
Prior to use, ensure any protective coverings or films that may have been placed over the clear grinding visor
or and viewing surfaces of the auto-darkening filter (ADF) viewing areas to protect it during manufacturing or
shipping are removed.
Connecting & Disconnecting Breathing Tubes
– Connect approved breathing tubes by pushing the QRS (Quick Release Swivel) end of the breathing tube (i.e.,
end with the black pinch clip) onto the air inlet of the headgear (Fig. 1a). The breathing tube should make an
audible click when attached. Verify breathing tube is secured to the headgear by swiveling and pulling on the
connection. If it is not securely connected, detach and reconnect.
– To disconnect the breathing tube, compress the tabs on the end of the QRS to release and pull back to
remove (Fig. 1b).
6 to 15 cfm (170 to 425 lpm)
Less than 80 dBA (excluding external noise)
-30ºC to 50ºC (-22ºF to 122ºF)*
Classification
Loose fitting facepiece
Welding Helmet/Hood
6
OSHA APF
1
25
1000