Publicidad
Idiomas disponibles
Idiomas disponibles
GB
DC Frequency Pressed.
By pressing function keys 31 e 32 the luminous indicator is position at 26- Fig. 1
page 3) ; then by activating the knob 30, the frequency for the DC TIG pressed is
set up.
The frequency can be regulated between the following ranges:
a) Between 0,3 Hz and 1Hz with a 0,1 Hz step.
b) Between 1 Hz and 250Hz with a 1 Hz step.
Descent Slope.
By pressing function keys 31 e 32 the luminous indicator is position at 27- Fig. 1
page 3) ; then by activating the knob 30, the time is set up in seconds either to
reach the final current welding in the Four Times mode, or to cancel the nominal
current welding in the Two Times mode.
The value range is between 0 and 10 seconds.
Final Current.
By pressing function keys 31 e 32 the luminous indicator is position at 28- Fig. 1
page 3) ; then by activating the knob 30, the value for the final current on the TIG
Four Times mode is set up. The value range is between I Min and the nominal cur-
rent welding.
FOUR TIMES FUNCTIONALITY FOR TIG WELDING
Post gas.
By pressing function keys 31 e 32 32 the luminous indicator is position at 29- Fig.
1 page 3) then by activating the knob 30, the time length for the final gas flux is
set up in seconds. The value range is between 0,2 and 20 seconds.
7.0 FOUR TIMES FUNCTIONALITY FOR TIG WELDING
The generator allows a management of the Four Times Intelligent mode. In fact,
it is possible to modify the automatic sequence depending on how the torch but-
ton is used (as shown in Figure 3).
The current's descent slope is also possible from the reduced current.
AUTOMATIC SEQUENCE
(GB) 6
Figure 3.
Pressure without the torch button release.
Torch button release.
Pressure and immediate release of the torch button.
Release and immediate pressure of the torch button.
GB
Publicidad
