cecotec BOLERO WASH&DRY 8580 INVERTER B Manual De Instrucciones página 103

3. PRODUCT INSTALLATION
1. Place the device on a flat, stable and dry surface. Make sure the product does not
stand on the power cord.
2. Never install it on a soft carpet or wooden floor, or on any kind of mezzanine.
3. The washer dryer may move a little during operation due to overload factors.
4. Avoid direct sunlight and ensure sufficient ventilation.
5. Keep the room environment dry and avoid humidity.
6. Remove the cardboard box and Styrofoam packing.
7. Free the power cable and the drain hose from the rear.
8. Remove any accessories that may be inside the drum, such as the water supply hose,
instruction manual, etc.
9. The washer dryer should be used in places where the temperature is between 5°C and
35°C. If used under 0°C, the inlet valve and draining system may be damaged.
10. Install the appliance ensuring sufficient space around it (Fig. 3):
a: minimum 3 cm.
b: minimum 5 cm.
c: minimum 5 cm on the left side.
d: minimum 5 cm on the right side.
e: minimum 70 cm.
WARNING: do not allow metal parts of the appliance to come into contact with metal sinks
or other appliances.
Removing the transport screws (Fig. 4)
- The transport screws must be removed from the backside of the device before
installing it.
- IMPORTANT: it is imperative to remove the transport screws before the first use,
otherwise they may damage the drum during the operation of the device.
The transport screws will be necessary again when moving the product, so make sure
-
they are kept in a safe place.
In order to remove the screws:
-
- Loosen 4 screws with a spanner and then remove them (A).
- Remove the 4 tube spacers (depending on model) (B).
NOTE: during removal of the transport screws, occasionally the pipe spacers may fall
-
into the machine, if this happens, they can be accessed by tilting the machine forward
and picking them up from the floor or inside the base of the machine.
Cover the transport screw holes with the 4 supplied plugs (C).
-
- Keep the transport screws properly for future use. You will need them again if the
washer-dryer needs to be moved to another location.
If it is necessary to transport it to another location:
-
02770/71_BOLERO WASH&DRY 8580 INVERTER B/ INVERTER STEEL B_RP_01230629.indd 103 02770/71_BOLERO WASH&DRY 8580 INVERTER B/ INVERTER STEEL B_RP_01230629.indd 103
BOLERO WASH&DRY 8580 INVERTER B/STEEL B
ENGLISH
103
29/6/23 16:38 29/6/23 16:38