cecotec BOLERO WASH&DRY 8580 INVERTER B Manual De Instrucciones página 128

ENGLISH
Errors
Error
E02
E03
U4
BOLERO WASH&DRY 8580 INVERTER B/STEEL B
128
02770/71_BOLERO WASH&DRY 8580 INVERTER B/ INVERTER STEEL B_RP_01230629.indd 128 02770/71_BOLERO WASH&DRY 8580 INVERTER B/ INVERTER STEEL B_RP_01230629.indd 128
Cause
No water in
Drain failure
Door lock fault
Solution
Check if the tap is open. If the
water supply is cut off. Are
the mesh filter in the water
supply hose and the water
inlet valve blocked? What if
the water supply hose of the
appliance is frozen? Eliminate
the above causes of failure.
If the fault code still exists,
please contact the Cecotec
Technical Support.
Clean the pump filter.
Check if the drain hose is
bent, kinked, or blocked.
Eliminate the above causes
of failure. If the fault code
still exists, please contact the
Cecotec Technical Support.
The door is not closed
properly and the door lock
does not function normally.
Close the door again, turn the
wash cycle selector to the
"OFF" position to turn off the
power supply, and then turn
the selector to select any
wash programme and press
the START/PAUSE button
to restart the programme.
Eliminate the causes of this
failure. If the fault code still
exists, please contact the
Cecotec Technical Support.
If the fault code appears and
you cannot open the door,
the door lock may be faulty,
please contact Cecotec
Technical Support.
29/6/23 16:38 29/6/23 16:38