Wool
Cycle designed for woollen garments.
IMPORTANT: after use, confirm that the garments have not been damaged or shrunk.
Delay End
Press the Delay End button to set the programme end time, which is incremented in
one-hour intervals, up to a maximum of 24 hours. After selecting the desired wash
programme, but before pressing the START/PAUSE button, press the Delay End button until
the desired time is displayed, e.g., 8h, with the Delay End indicator light on.
NOTE: the cycle time is included in the set deferred end time.
Example of a cycle time of 1 hour and 30 minutes and a delayed end time of 8 hours.
8 h is shown on the display and a countdown (approx. 6 hours and 30 minutes) until the
wash cycle starts, then the cycle duration 1: 30 is shown and starts. The total time is
approximately 8 hours.
The way to cancel the deferred termination function is as follows:
-
Turn the wash cycle selector to reset the wash cycle. The "Delayed Completion"
indicator light will go out.
NOTE:
-
The delay end function cannot be set in some wash cycles.
-
The actual end time of the wash cycle may be different from the set delayed end
time, depending on multiple factors such as water supply pressure, drainage, type of
laundry, water temperature, as well as other conditions.
Child Lock
1. The setting of the child lock function can prevent malfunctions or unwanted incidents.
2. During operation, press and hold the SPEED button for approximately 3 seconds to set
or cancel the child lock function.
3. After setting the child lock function, its indicator light comes on, the door cannot be
opened and the control panel is locked, the buttons remain inactive, as well as the
wash cycle selector (the indicator light below the power symbol is on
can only be switched off by turning the wash cycle selector to its OFF position, the
indicator light below the power symbol will go out and the device will stop operating. If
the machine is switched off, the child lock function will be cancelled.
4. When the machine is switched on again, it will directly run the selected programme
before it was switched off.
Stain removal
This option allows you to select the type of stains on the laundry for better efficiency
during washing.
02770/71_BOLERO WASH&DRY 8580 INVERTER B/ INVERTER STEEL B_RP_01230629.indd 117
02770/71_BOLERO WASH&DRY 8580 INVERTER B/ INVERTER STEEL B_RP_01230629.indd 117
BOLERO WASH&DRY 8580 INVERTER B/STEEL B
ENGLISH
). The machine
117
29/6/23 16:38
29/6/23 16:38