Descargar Imprimir esta página

cecotec BOLERO WASH&DRY 8580 INVERTER B Manual De Instrucciones página 104

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 67
ENGLISH
1. Reinstall the transport screws.
2. Secure the power cable to the rear of the appliance.
Levelling the washer dryer
The appliance reaches high spin speeds to remove water at the end of the wash cycle.
Therefore, it is important that it is level and that all 4 legs press against the floor with the
same pressure.
This will help to ensure quieter operation and less vibration.
Carry out the following steps:
-
Install the appliance on a solid, level surface. Preferably in a corner of the room.
If the floor is uneven, adjust the legs as necessary to level the device. Do not place any
-
objects under the legs in an attempt to level it.
-
Do not extend the legs more than necessary. The more extended, the more vibrations
the device will suffer. Start with the legs all the way in and adjust each one as
necessary.
-
You can use a spirit level (not included) to check that the appliance is level.
Press down on each corner of the top of the equipment to ensure that it does not
-
"wobble".
-
All legs must press equally against the floor.
When the device is level and does not wobble, lock the legs by tightening the lock nuts
-
against the bottom of the equipment. Be sure to do this without changing the height of
the leg (hold the leg while tightening the lock nut). Fig. 5
Connection of the supplied hoses
Water supply hose connection
1. Connect one end of the water supply hose to a cold water tap and tighten by hand (Fig.
6). Before making the connection, allow the water to run freely until it runs completely
clear.
2. Connect the other end of the water supply hose to the water inlet valve at the rear by
turning clockwise (Fig. 7).
3. Open the tap slowly and make sure there are no water leaks.
Warning
-
Do not kink, crush, modify or sever the water inlet hose.
-
Squeeze the end of the hose firmly by hand.
The water supply pressure must be within a range between 0.03 and 1 MPa. If
-
the pressure exceeds this value, a pressure reducing valve (not included) must be
installed.
-
If the hose is not long enough, please contact a specialised retailer, an authorised
BOLERO WASH&DRY 8580 INVERTER B/STEEL B
104
02770/71_BOLERO WASH&DRY 8580 INVERTER B/ INVERTER STEEL B_RP_01230629.indd 104
02770/71_BOLERO WASH&DRY 8580 INVERTER B/ INVERTER STEEL B_RP_01230629.indd 104
29/6/23 16:38
29/6/23 16:38

Publicidad

loading

Este manual también es adecuado para:

Bolero wash&dry 8580 inverter steel b0277002771