cecotec BOLERO WASH&DRY 8580 INVERTER B Manual De Instrucciones página 12

SAFETY INSTRUCTIONS
Read these instructions thoroughly before using the
device. Keep this instruction manual for future reference
or new users.
- Ensure that the mains voltage matches the voltage
specified on the device rating label and that the plug
is earthed.
- If the power cord is damaged, it must be replaced by
the official Cecotec Technical Support Service or by a
similarly qualified person to prevent hazards.
- This appliance is for indoor use only.
- The device is not designed for built-in installation.
- Use the hose set supplied with the appliance. Do not
reuse old hoses.
- Check hose connections regularly to ensure that no
water leaks out.
- Do not use the appliance if parts are missing or
defective or if the power cord or plug is damaged.
- Do not use the appliance until you are sure that it is
installed in accordance with the instructions provided
in this manual and all water, drain, electrical and
grounding connections comply with all applicable
local regulations and/or other requirements.
- Before carrying out any maintenance or cleaning in
the device, unplug the appliance from the mains.
- As a safety measure, we advise you to unplug the
appliance and cut the water supply after every use.
Maximum water-inlet pressure: 1 MPa. Minimum
water-inlet pressure: 0.03 MPa.
- Never unplug the appliance with wet hands.
- To ensure your safety, power plug must be inserted
BOLERO WASH&DRY 8580 INVERTER B/STEEL B
12
02770/71_BOLERO WASH&DRY 8580 INVERTER B/ INVERTER STEEL B_RP_01230629.indd 12 02770/71_BOLERO WASH&DRY 8580 INVERTER B/ INVERTER STEEL B_RP_01230629.indd 12 29/6/23 16:38 29/6/23 16:38