cecotec BOLERO WASH&DRY 8580 INVERTER B Manual De Instrucciones página 106

ENGLISH
Note:
- Do not twist, pull, or bend the drain hose.
- Fix the hose with a hose clamp to the drainpipe, sink/washbasin, etc., so that the hose
will not be forced out by the force of the water.
- For added safety, you can also use a drain hose holder (not included) and install the
hose over a sink/washbasin or tank, as shown in Figure 11.
The use of hose extensions is not recommended; if absolutely necessary, the
-
extension should have the same diameter as the original hose and should not exceed
250 cm in length (Fig. 12).
If drain hose is too long, do not force it into the washer dryer as it will cause abnormal
-
noises.
After installation, wait a few hours before operating the appliance to allow it to
-
acclimatise to the ambient conditions in the room.
- Only connect the device when the installation has been completed.
4. OPERATION
Note
- Before washing the clothes for the first time, the product shall be operated in one
round of the whole procedures without the clothes inside.
Control panel. (Fig. 13)
A: Wash cycle button/selector
Used to programme the desired wash cycle.
OFF position: turn the wash cycle selector, when the indicator light below the symbol
is on, the machine will stop running and turn off. If the machine is switched off during a
wash cycle, the wash cycle will be cancelled.
B: TEMP
Press the button to change the water temperature of the selected cycle, the temperature
value will appear on the display.
C: SPEED
Press the button to change the spin speed of the selected cycle, the speed value will
appear on the display.
CHILD LOCK FUNCTION
When a wash cycle is running, if you want to activate the child lock, press and hold the
SPEED button for about 3 seconds.
BOLERO WASH&DRY 8580 INVERTER B/STEEL B
106
02770/71_BOLERO WASH&DRY 8580 INVERTER B/ INVERTER STEEL B_RP_01230629.indd 106 02770/71_BOLERO WASH&DRY 8580 INVERTER B/ INVERTER STEEL B_RP_01230629.indd 106 29/6/23 16:38 29/6/23 16:38