cecotec BOLERO WASH&DRY 8580 INVERTER B Manual De Instrucciones página 118

ENGLISH
The appliance adjusts the average wash temperature, drum movement and soaking time
to the specific type of stain. Hot or cold water, gentle or intensive washing and long or
short soaking ensure that the washing sequences are specially adapted to each type of
stain. Selecting this option ensures that the stains are treated in the best possible way.
NOTICE: pressing and holding the STAINS button automatically runs through the set type of
stains.
The duration of the wash cycle varies according to the type of soiling selected.
Before the first wash
All washer dryers are tested before leaving the factory under strict quality control. This
process involves running several wash cycles. As a result, a small amount of water may
remain in the drum and drainage system. Run a "Drum Clean" cycle without laundry to
clean the system before your first load of laundry.
First add 1 or 2 tablespoons of detergent to compartment I of the detergent dispenser.
Then run the "Drum Clean" cycle.
Wait for the cycle to finish.
How to use the washer dryer
1. Load the laundry
Open the door and insert the laundry into the drum. Load the items one at a time without
squeezing them or overfilling the drum, place them evenly. Please note the load sizes
indicated in the "Washing cycle table". Overloading of the machine will result in non-optimal
washing and wrinkled laundry.
2. Close the door
Make sure that there are no dirty clothes between the door glass and the rubber seal. Close
the door, make sure you hear the "click" as it closes.
3. Open the tap
Make sure that the appliance is connected to the water mains. Open the tap.
4. Set the desired programme
Select the required programme with the washing programme selector. The duration of
the wash cycle is shown on the display. The machine automatically displays the default
temperature and possible spin speed settings for the selected programme. Adjust the
temperature and/or spin speed settings, if necessary, with the corresponding buttons.
- Change the temperature, if necessary
Press the TEMP (Temperature) button to progressively decrease the temperature setting until
cold wash is reached ("--" will be displayed on the digital display). Pressing the button again
sets the highest possible setting.
BOLERO WASH&DRY 8580 INVERTER B/STEEL B
118
02770/71_BOLERO WASH&DRY 8580 INVERTER B/ INVERTER STEEL B_RP_01230629.indd 118 02770/71_BOLERO WASH&DRY 8580 INVERTER B/ INVERTER STEEL B_RP_01230629.indd 118 29/6/23 16:38 29/6/23 16:38