Publicidad
Idiomas disponibles
Idiomas disponibles
• Use a new oil filter of the same model and
apply a layer of lubricating oil to the O-ring
(figure ĺ position).
Notice
Please do not remove the O-ring of the oil filter, as
this will cause the sealing ring to not be installed in
place, resulting in oil leakage or engine damage.
• Install the new oil filter on the engine by hand
until the hand does not work, and then tighten
the oil filter with a torque wrench with 20N.m
torque.
2. Inject about 1.3L of oil into the engine until the oil
reaches the upper limit of the oil scale.
3. Put in the oil refueling cover.
4. Start the engine, let the engine turn at idle speed
for a few minutes, and then turn off the engine.
5. Check the oil quantity position of the oil scale
again, the oil level must reach the upper limit
mark position, at the same time, there is no oil
leakage phenomenon in the engine.
6. If there is a splash of oil, please wipe it clean.
Spark plug
At the beginning of the riding 1000km,
and each time 3000km is driven, the
carbon deposit attached to the spark
plug is removed with a small metal
wire brush or spark plug cleaner, and
the electrode gap of the spark plug is
readjusted with the spark plug gap
thickness measuring piece to keep it
between the 0.7-0.8mm.
Spark plug model: CR8E
Caution
Do not screw the spark plug too tightly or inter-
laced the threads so as not to damage the threads
of the cylinder head. When removing the spark
plug, do not allow impurities to enter the engine
through the spark plug.
25
0.7-0.8mm
Publicidad
