Publicidad
Idiomas disponibles
Idiomas disponibles
handle of the vehicle, and if the liquid level is below
the lower limit calibration line of the liquid cup or
the lower limit mark of the liquid cup liquid level
MIN, the specified brake fluid shall be added as
appropriate; the rear fluid reservoir shall be
installed in the middle of the right side of the vehi-
cle, and the liquid level of the rear fluid reservoir
shall be between the MIN (or LOWER) and MAX
(or UPPER) engraving lines, and if the liquid level
is lower than the MIN (or LOWER) engraving line,
the specified brake fluid shall be added. Supple-
mentary brake fluid should be considered neces-
sary for regular maintenance.
Caution
This car uses DOT4 brake fluid. Do not use the
residual liquid from the open cylinder and the
brake fluid left behind by the last maintenance, as
the old liquid will absorb water from the air. Be
careful not to splash the brake fluid on the paint or
plastic surface, it will erode the surface of these
substances.
Braking system
The braking systems that should be checked on a
daily basis are as follows:
• Check whether there is leakage in the front and
rear wheel braking system.
• Brake handle and brake pedal to maintain a cer-
tain reverse support force.
• To check the wear condition of the friction plate. If
the groove bottom line scratches are exceeded, the
two friction plates should be replaced together.
Warning
If the braking system or friction disc needs to be
repaired or replaced, we suggest that you hand
over the work to the maintenance service center.
They have a full range of tools and skilled skills to
do the job in the safest and most economical way.
When the new disc friction disc is first replaced, the
brake handle is grasped several times, so that the
friction plate is fully stretched and the normal han-
dle back support force is restored, and the brake
fluid is stable and circulating.
30
Publicidad
