Medion LINE E11916 Manual De Operación página 166

buttons  to select the transponder for
which you want to start the search. Now press
the O K button to mark the relevant tran-
sponder with a red tick.
ADD
Press the yellow button to add a new tran-
sponder. Enter the required values and con-
firm with O K or press E X I T to cancel the
process.
FRE
Enter the frequency using the
QUENCY
number buttons.
SYMBOL
Enter the symbol rate using the
(KS/S)
number buttons.
POLARITY Select the polarity with .
DELETE
Select the transponder that you want to delete
from the list as described above and press the
red button. Confirm the query with JA.
EDIT
The setting options correspond to those for
ADD.
SCAN
The setting options correspond to those for
SCAN under Satellite.
– LNB TYPE
Enter the oscillator frequency for your
LNB type here. The default setting is
/.
The following UNICABLE SETTINGS can be
made here.
You can set the LNB frequency
LNB TYPE
here
IF CHAN
You can set the IF channel here
NEL
CENTRE
You can set the centre frequen-
FRE
cy here
QUENZ
SAT POS
You can set the satellite position
TION
here
– LNB POWER
Set the LNB power here.
– KHZ
Set the sound here, the default setting is
AUTO.
20
– TONEBURST
If your satellite system requires a tone burst,
you can set it to BURST A or B here.
– DISEQC ./.
If you have connected multiple LNBs or a DiS-
EqC switch to your satellite antenna, set the
desired LNB here.
– MOTOR
If your satellite antenna is controlled by a
motor, select the desired DiSEqC version with
. Press the O K button to define the posi-
tion of the antenna.
In order to start the search, press the blue button (SCAN)
and confirm with O K .
10.2. Picture menu
PICTURE
Picture Mode
Contrast
Brightness
Colour
Tint
Sharpness
Colour Temp
Noise Reduction
Overscan
Backlight
Move
PICTURE MODE
Select picture mode: STANDARD, DYNAMIC, MILD,
STANDARD, DYNAMIC, MILD, PERSONAL. This func-
tion corresponds to the P. M O D E button.
In the PERSONAL setting, you can set the CONTRAST,
BRIGHTNESS, COLOUR, TINT and SHARPNESS your-
self. These parameters cannot be changed in the other
settings.
CONTRAST
Increase or decrease contrast (on a scale of 0 – 100).
BRIGHTNESS
Increase or decrease brightness (on a scale of 0 – 100).
COLOUR
Increase or decrease the colour (on a scale of 0 – 100).
TINT
Hue settings only available for NTSC reception.
SHARPNESS
Increase or decrease sharpness (on a scale of 0 – 100).
COLOUR TEMP
Select colour temperature: COLD, NORMAL and
WARM.
NOISE REDUCTION
This function reduces picture noise and improves picture
quality when the signal is weak. Select between OFF,
LOW, MIDDLE, HIGH and DEFAULT.
Standard
50
50
50
50
50
Normal
Middle
Auto
80
Return Select
MENU OK
EXIT
Exit