EN-6
Safety Protection Measures
CAUTION: Read all safety warnings before installing, connecting, or
servicing this equipment. Failure to comply with these warnings could
result in personal injury and/or property damage. Retain all instructions
for future reference.
Do not operate the device in a damp, dangerous, or unstable environment.
Please follow the instructions provided by the chemical manufacturer and
general laboratory safety procedures when using chemicals and solvents.
Do not allow liquid to enter the device.
Use only approved accessories and peripherals.
Repair service can only be performed by authorized personnel.
Special reminder: Keep chemical reagents away from minors
Warning label: Please pay special attention to the label attached to the
instrument. If you do not pay attention, it may cause damage to the
operator or the instrument.
WARNING: Please follow the instructions provided by the chemical
manufacturer and general laboratory safety procedures when using
chemicals and solvents.
WARNING: Do not operate the device in an environment with explosion
hazards! The meter housing is not airtight. (Explosion hazard caused by
spark formation, and corrosion caused by gas ingress)
WARNING: There is an electrical shock hazard within the housing. Only
authorized and qualified personnel can open the housing. Please
disconnect all power connections to the device before opening.
1.2. Intended Use
This meter is applicable to laboratories, pharmacies, schools, enterprises, and light
industry. This meter is only used for measuring the parameters described in this
instruction manual. Any other type of use and operation beyond the limits of the
technical specifications is considered as an unintended use without the written
consent of Ohaus. This meter complies with current industry standards and
recognized safety regulations; danger may occur during use. If this meter is not used
in accordance with this instruction manual, the expected protections provided by the
meter may be impaired.
a-AP50MM