Publicidad
Idiomas disponibles
Idiomas disponibles
EN-8
30727772
30727773
30727774
30727775
30727776
30744416
2.3. Battery Installation
The AP50MM is powered by four AA-size alkaline batteries. Do not use
rechargeable nickel cadmium (NiCad) batteries or any AA-size lithium batteries. A
set of batteries typically lasts for three months. When the batteries capacity is low,
the AP50MM will prompt a LOW BATTERY warning. Replace all four batteries to
resume operation of the AP50MM after the battery warning.
The AP50MM battery compartment, shown in Figure 1, is on the back side of the
instrument. Insert a small pad underneath the screen area to make the back-
surface level when the instrument is turned upside down. Install batteries as
followings:
1.
Remove the battery compartment cover by loosening four screws.
2.
Insert four batteries into the battery holder as shown in Figure 1. Make
sure the positive battery polarity marker (+) is aligned with the positive
marker (+) on the battery holder.
3.
Replace the battery compartment cover, making sure that the sealing
O-ring is lying flat on the battery holder and tighten the four screws.
Cleaning brush pk/5
Cloth pk/4
Screwdriver pk/2
Micro USB cable pk/2 a-AP30
Cylinder 5mL pk/2
Briefcase AQUASEARHER
Figure 1 Replace Batteries
a-AP50MM
Publicidad
