Descargar Imprimir esta página

Brandt BOP7537 BB Instrucciones Para El Usuario página 147

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 158
How to use your appliance
Cleaning
CLEANING INSIDE - OUTSIDE
• Self-cleaning of the cavity by pyrolysis
Warning
Remove the accessories and wire tiers from the oven before starting a pyrolysis cleaning.
Before starting a pyrolysis cleaning of your oven, remove any large overflows that may have
occurred. Remove excess grease from the door with a damp sponge.
For safety reasons, the pyrolysis cleaning operation is only carried out after the door has been automati-
cally locked, the door cannot be unlocked.
• Immediate self-cleaning
The timer should display the time of day, without flashing. Select one of the self-cleaning cycles with the
function lever
or
= Cleaning in 39 minutes
- At the end of each cooking cycle, "Clean 39" scrolls on the screen, suggesting that you start the cleaning
process. Position the lever on this function and confirm with the key
nating with "Clean 39", your cleaning starts. After a few minutes, a key appears and the oven door is au-
tomatically locked for safety reasons during the entire programme.
If you wish to start a "Clean 39" oven that is cold or not hot enough, the program start conditions will not
allow this cleaning to take place. 0:00 will appear on the display and you will have to select the other
self-cleaning position.
= Pyrolysis of 2 hours. Set the joystick to this function.
Set the joystick to this function.
ding to the degree of soiling of your oven.
Depending on your choice, the duration 2:00 is displayed. Confirm with the
pyrolysis starts.
At the end of the cleaning process the display shows 0:00 and the door unlocks.
Reset the function selector switch to 0.
• Delayed self-cleaning
You have the possibility to postpone the departure of your Pyrolysis. When the duration of the programme
is shown on the display, press the button
with
. Self-cleaning will start later and finish at the new programmed time. Reset the function selector
switch to 0 at the end of the cleaning process.
:
.
is displayed on the screen. Press + to choose your pyrolysis accor-
and set the new end time using the + and - keys, then confirm
. The time 0:39 is displayed alter-
.
displayed, the
17

Publicidad

loading

Este manual también es adecuado para:

01050046