Franklin Electric COVERCO QC-AV Manual Del Usuario página 14

External switch
A float switch, pressure switch or any other external switch can be used to supply
power to the panel. In this case, leave the ON/OFF switch in the ON position.
For the COV BOX T control panel only: the switching capacity required of the external
switch is 400V/1A unipolar.
Starting cycles
The submersible motor generates a certain amount of heat each time it is switched
on. Thus, it must run for a given period of time so as to dissipate the heat. Starting
the motor too often could lead to failure to dissipate heat and the motor could be
damaged. Thus, observe the motor starting cycles/time specifications provided for by
the instructions manual.
Maintenance
The control device and its components do not require any maintenance whatsoever.
Troubleshooting
Condition/Failure
Motor / pump does not start
Motor / pump does not switch off
Motor / pump switches on and off
repeatedly
14
If a repeated overload condition occurs, contact your installer
or support centre.
Cause/Remedy
Loss of power
Check mains voltage (are other connected
appliances working?)
Damaged switch
Contact your support centre
Overload protection tripped
Restore overload protection
Damaged switch
Contact your support centre
Faulty float or pressure switch
Contact your support centre
Doc. Name: ManualeQuadriControllo2018 / Rev. Date: 3/10/2018