Parkside PWSA 20-Li D4 Traduccion Del Manual De Instrucciones Originale página 28

GB MT
Technical data
Cordless Angle Grinder ..............
........................... PWSA 20-Li D4
Motor voltage ............................. 20 V
Idling speed (n) ............ 2500-11500 min
Cutting­/­roughing­/­grinding­discs
Outside diameter ........ max. Ø 125 mm
Bore hole ............................ 22.23 mm
Thickness ........................... max. 6 mm
Spindle thread .................................M14
Thread­length .............................. 11 mm
Sound pressure level
(L ) ................... 83.1 dB(A); K
pA
Sound power level (L
measured .......... 94.1 dB(A); K
Vibration level (a )
h
Device handle .. 3.38 m/s
Handle ........... 3.73 m/s
Vibrations levels are the maximum values
generated by the cutting discs supplied.
The­actual­vibration­values­may­vary­de-
pending on the used accessories.
The­vibration­values­are­still­affected­by­
the handling for the user's.
Cutting disc .......... PTS 125 A24QBF
Idling speed n ..................12200 min
max
Disc speed v ............................ 80 m/s*
0
Outer diameter ................... Ø 125 mm
Bore hole ........................ Ø 22.23 mm
Thickness ................................... 1 mm
*
The cutting disc must withstand a rotational
speed of 80 m/s.
Levels of noise and vibration were determi-
ned according to the norms and regulati-
ons in the declaration of conformity.
The­vibration­emission­value­has­been­
measured according to a standardised
28
= 3 dB
pA
)
WA
= 3 dB
WA
; K= 1.5 m/s
2
2 ; K= 1.5 m/s
(included)
testing method and may be used for com-
parison with another electric tool.
The­indicated­vibration­emission­value­
may also be used for an introductory
-1 assessment of the exposure.
Warning:
The­vibration­emission­value­whilst­
actually using the electrical tool
may vary from the given values in-
dependently of the type and way in
which the electric tool is used.
­ Try­to­keep­the­exposure­to­vibra-
tions as low as possible. Examples
of measures to reduce vibration
exposure are the wearing of gloves
when using the tool and limiting the
2
2 working hours. For this purpose all
parts of the operating cycle have to
be considered (for example, times
when the electric tool is switched off
and times when it is switched on but
running without any load).
Charging time
The­device­is­part­of­the­Parkside­X 20 V­
TEAM­series­and­can­be­operated­with­bat-
teries­of­the­Parkside­X 20 V­TEAM­series.­
-1
Batteries­of­the­Parkside­X 20 V­TEAM­
series may only be charged using chargers
of­the­Parkside­X 20 V­TEAM­series.
We recommend that you operate this ap-
pliance with the following batteries only:
PAP 20 B1,­PAP 20 B3
We recommend charging these batteries
with­the­following­chargers:­PLG 20 A3,­
PLG 20 A4,­PLG 20 C1,­PLG 20 C2­
PLG 20 C3,­PDSLG 20 A1
An up-to-date list of battery compatibility
can be found at: www.lidl.de/akku