Parkside PWSA 20-Li D4 Traduccion Del Manual De Instrucciones Originale página 36

GB MT
• Be aware that the wire brushes
also lose wire pieces during typi-
cal use. Do not overload the wi-
res by pressing down too hard.
Flying wire pieces can very easily penet-
rate thin clothing and/or your skin.
• If a protective hood is recom-
mended, do not allow the wire
brushes and the protective hood
to touch each other. The­diameter­
of plate and cup brushes can enlarge if
too much pressure and centrifugal force
is exerted.
Additional safety
instructions
• Only use grinding discs where the in-
dicated rotational speed is at least as
high­as­what­has­been­specifi ­ ed­on­the­
name plate of the device.
•­ Carry­out­a­visual­inspection­of­the­
grinding disc before use. Do not use
any damaged or deformed grinding
discs. Replace any damaged or worn
grinding discs.
• Make sure that the sparks produced by
grinding do not present a danger, e.g.
reach­people­or­ignite­fl ­ ammable­subs-
tances.
• Always wear safety goggles, safety
gloves, respiratory protection and ear
protection when grinding, brushing and
cutting.
•­ Never­keep­the­fi ­ ngers­between­the­
grinding disc and spark protection or in
close proximity to the protective hoods.
There­is­a­risk­of­crushing.
•­ The­rotating­parts­of­the­device­cannot­
be covered due to functional reasons.
Therefore,­proceed­cautiously­and­hold­
the­workpiece­fi ­ rmly­in­order­to­avoid­
slipping which could cause your hands to
come into contact with the grinding disc.
36
•­ The­workpiece­gets­hot­during­grinding.­
Do not touch the machined area, allow
it­to­cool­down.­There­is­a­risk­of­bur-
ning. Do not use coolants or the like.
• If you are tired or have consumed al-
cohol or tablets, do not work with the
device. Always have a break on time.
• Switch off the device and remove the
battery from the device
- to loosen a blocked insertion tool,
- if the connection line is damaged or
entangled,
- in case of unusual sounds.
RESIDUAL RISKS
Even if properly operating and handling this
electric tool, some residual risks will remain.
Due to its construction and build, this electric
tool may present the following hazards:
a) Lung damage if suitable respiratory
protection is not worn.
b) Hearing damage if suitable ear protec-
tion is not worn.
c) Damage to health due to
- touching the area of the grinding tool
which is not covered;
- ejection of parts of workpieces or
damaged grinding discs.
d) Health injuries which result from swin-
ging hand and arm, in the event that
the device is used over a longer period
of time or is not used and maintained
properly.
Warning! During operation, this
electric tool generates an electro-
magnetic­fi ­ eld­which,­under­certain­
circumstances, may impair the
functionality of active or passive
medical­implants.­To­reduce­the­risk­
of serious or lethal injuries, we re-
commend that persons with medical
implants consult their doctor and the