Parkside PWSA 20-Li D4 Traduccion Del Manual De Instrucciones Originale página 43

devices that you send to us free of
charge.
­ This­does­not­affect­accessories­enc-
losed with the old devices or tools wit-
hout any electrical components.
Troubleshooting
Remove the battery from the device before carrying out any maintenance, adjust-
ment­or­cleaning­work­on­the­device.­Danger­of­electric­shock!
Problems
Device doesn't start
Grinding tool does
not move although
the engine is run-
ning
Engine is slower
and stops
Grinding disc does
not rotate smoothly,
abnormal noises
can be heard
Possible Cause
Battery (5) discharged
Battery (5) not inserted
On/off switch (3) may be de-
fective
Engine faulty
Grinding disc nut is loose
Workpiece, remaining workpie-
ces or remaining grinding tools
block drive
Device is overloaded through
workpiece
Grinding disc nut is loose
Grinding disc is defective
Error correction
Charge­the­battery­(observe­the­
separate operating instructions
for the rechargeable battery and
charger)
Insert battery
(see 'Operation')
Repair­by­Customer­Care
Tighten­grinding­disc­nut­(see­
„Installing/changing disc")
Remove blockages
Reduce pressure on grinding tool
Workpiece unsuitable
Tighten­grinding­disc­nut­(see­
„Installing/changing disc")
Change­grinding­disc
GB MT
43