Lukas e3 CONNECT Manual De Instrucciones página 30

6.3.1. SWITCHING ON ROUTER MODE ON THE DEVICE
de
To do this, move the star grip all the way to the right (figure H) and simultaneously
press the main switch (figure M; no� 1) for 15 seconds� The rescue device now
en
establishes a WLAN network�
fr
6.3.2. SEARCHING FOR A RESCUE DEVICE WITH WLAN CAPABILITY
The network established by the rescue device can be found by a WLAN-capable
es
device (mobile phone, tablet or laptop)� Search in the available networks for the
"Jaws of Life" network and enter the password "12345678"�
pt
6.3.3. AFTER SUCCESSFUL CONNECTION
it
If there is a WLAN connection, scan the QR code (figure O) on the rescue device
or enter the IP address http://192.168.66.1/ into the Internet browser of your termi-
nl
nal device� Now the input screen for the network connection opens (figure P)�
da
6.3.4. INPUTTING THE NETWORK INTO THE PAIRING APP
Now choose your network with which the rescue device is to communicate� To do so,
sv
the network name (figure P; no� 1) and password (figure P; no� 2) is required� The pass-
word (figure P; no� 3) must be entered twice� Between one and ten networks can be
fi
stored, via which the rescue device should exchange data with Captium� After you have
entered the first network, confirm with the Next button (figure P; no� 4)� After that, anoth-
el
er network can be entered� After all networks have been entered, end the process by
pressing the Finish button (figure P; no� 5)� A confirmation screen appears, the WLAN
pl
symbol (figure M; no� 8) flashes and the workspace lighting is switched back on� Make
sure that the following ports have been enabled in the network to be connected�
cs
Port
sk
123
hu
8883
ro
443
bg
6.4. REGISTERING THE DEVICE IN CAPTIUM
sl
Visit captiumconnect�com and locate the Support Center� There you will find
instructions for how to sign up for an account, register your device, how to use the
hr
Captium Data Hub and much more�
et
6.5. AUTOMATIC SENDING OF PROCESS DATA
lv
While you are working with the rescue device, the process data is collected in the
internal memory� If there is data in this memory, a battery is plugged in, and the device is
lt
switched off, the rescue device will then search every 20 minutes for the networks it rec-
ognizes� If no connection with a network is possible, it will search again after 20 minutes�
zh
After three attempts, the rescue device will wait 45 minutes before carrying out a final
search, after which it will interrupt the search and leave the data in the internal memory�
ko
If the rescue device can establish a connection, it sends the data to Captium and deletes
the entry in the internal memory as soon as Captium has received the data� If the inter-
ja
nal memory does not contain any data, the rescue device doesn't search for a network�
ar
30
Protocol Purpose
UDP & TCP Used to synchronize the time on the rescue device over
the Internet via NTP�
UDP & TCP IoT Hub MQTT connection�
UDP & TCP Device Provisioning Service HTTPS connection�