Publicidad
Idiomas disponibles
Idiomas disponibles
7. MAINTENANCE AND CARE
de
7.1. GENERAL MAINTENANCE
en
A visual check is to be carried out after each use� After every use, the lubrication of
fr
the moving parts and bolts must be checked and topped off with a suitable grease,
if necessary� The torque of the central bolt on cutting and combination tools must
es
also be checked� To do so, check the specifications in the spare parts lists�
Any dirt must be removed with a damp cloth� The rescue device should not come
pt
into contact with acids or alkalis� If this is unavoidable, clean the device immediate-
ly afterwards�
it
An annual inspection of the device is due each year and must be documented�
The annual inspection must be performed by a person with the necessary exper-
nl
tise� A function and load test must be conducted every three years or in case of any
safety concerns� Only testing equipment approved by LUKAS may be used� Please
da
also observe the relevant domestic and international regulations on the mainte-
sv
nance intervals of rescue devices�
7.2. MAINTENANCE AFTER UNDERWATER USE
fi
•
Remove the battery after use� Rinse the device and battery several times in
el
fresh, clean water� Immerse the device completely in order to fill the housing
with clean water� Lift the device out and let it drain completely� Depending on
pl
the type of water (mud, sludge, algae, salt water, etc�) in which the device was
used, repeat these steps another 2-5 times�
cs
•
Wipe the device and the battery with a clean, dust-free and damp cloth in
sk
order to remove any dirt and deposits�
•
Perform function test�
hu
•
Leave the device to dry at room temperature in a well-ventilated location� 36 to 48
hours is recommended� During this drying time, the device is completely operational�
ro
For the rechargeable battery, observe the relevant instructions�
bg
•
Lubricate all exposed steel parts (shear blade, pressure piece, etc�) with anti-
corrosion agent� The contacts in the battery shaft may not be lubricated�
sl
7.3. SHARPENING THE BLADES
hr
Any burrs may be removed and the blade smoothed only in the grinding area
(Picture)! Chips or deep cracks cannot be ground away� The blades must be re-
et
placed in this case�
lv
Tools required:
1�
Clamping device (e�g�, vise) with jaw protection
lt
2�
Grinder (e�g� angle grinder or belt grinder) with an abrasive that has a grain
size of 80� A diamond file is adequate for small burrs�
zh
Procedure:
ko
1�
Clamp the blade securely into the clamping device so that it cannot move,
leaving the grinding area exposed (figure N)�
ja
2�
Carefully de-burr the grinding area with the grinding machine (figure N)�
ar
32
Publicidad
