[Loop Handle Models] Trimmer Operating Position; Cutting With Trimmer Head - Maruyama B23L Manual Del Propietário

232025-04 12.11.30 11:49 AM ページ 21
[Loop Handle Models]
Trimmer Operating Position
Hearing Protection
Right Arm
Slightly Bent
Hand Holding Throttle Grip,
Fingers on Throttle Trigger
Before using the Trimmer, check the following:
1. Make sure the 3mm hex wrench has been removed
from the gearcase and boss adapter before you star
the engine.
2. The Trimmer should be on the operator's right side.
3. The operator's right hand should be holding the
shaft grip, with his or her fingers on the throttle
trigger. The right arm should be slightly bent.
4. The left hand should be holding the loop handle
with the fingers and thumb fully enclosed around
the grip. The left arm should be extended.
Reposition the loop handle up or down the drive-
shaft if necessary for a comfortable position.
5. The Trimmer weight should be evenly distributed
between the arms. The trimmer head should be
near and parallel to the ground.
6. Accelerate and hold the engine at cutting speed
before entering the material to be cut.
7. Always release the throttle trigger and allow the
engine to return to idle speed when not cutting.
8. Stop the Trimmer engine when moving between
work sites.
232025-10.indd 20
Eye Protection
Left Arm Fully Extended,
Hand Holding Loop Handle
Trimmer Head Near
and Parallel to Ground
— US-20 —
CAUTION
• Always wear gloves and protective cloth-
ing when operating the String Trimmer.
• If the trimmer head becomes jammed, stop the
engine immediately.
• Make certain all moving parts have stopped and
disconnect the spark plug before inspecting the
equipment for damage.
• Never use a String Trimmer that has chipped,
cracked or broken trimmer head.

Cutting with Trimmer Head

• The tip of the line does the cutting. The line
should stay extended while cutting.
Three inches
(7.6 cm) Above
Ground
CORRECT
• Do not force the line into the material. Forcing
the line will cause it to slap against the material,
increasing line usage and causing poor cutting
results.
13/12/25 14:51