Operation; Trimmer Operating Position - Maruyama BT230L Manual Del Propietario U Operador

Operation

WARNING
POTENTIAL HAZARD
• Foreign objects can be thrown by
String Trimmer.
WHAT CAN HAPPEN
• Contact with thrown objects can cause
personal injury.
HOW TO AVOID THE HAZARD
• Never operate the String Trimmer
without the debris shield in place.
CAUTION
• Read the Safety instructions on US-7
concerning proper use of the String
Trimmer.

Trimmer Operating Position

Hearing Protection
Right Arm
Slightly Bent
Hand Holding Throttle Grip,
Fingers on Throttle Trigger
CAUTION
• Always wear gloves and protective
clothing when operating the String
Trimmer.
Before using the Trimmer, check the following:
1. Make sure the Holding Tool (3mm hex wrench)
has been removed from the gearcase and boss
adapter before you star the engine.
Eye Protection
Left Arm Fully Extended,
Hand Holding Loop Handle
Trimmer Head Near
and Parallel to Ground
— US-17 —
2. The Trimmer should be on the operator's right side.
3. The operator's right hand should be holding the
shaft grip, with his or her fingers on the throttle
trigger. The right arm should be slightly bent.
4. The left hand should be holding the loop handle
with the fingers and thumb fully enclosed around
the grip. The left arm should be extended.
Reposition the loop handle up or down the shaft
assembly if necessary for a comfortable position.
5. The Trimmer weight should be evenly distributed
between the arms. The trimmer head should be
near and parallel to the ground.
6. Accelerate and hold the engine at cutting speed
before entering the material to be cut.
7. Always release the throttle trigger and allow the
engine to return to idle speed when not cutting.
8. Stop the Trimmer engine when moving between
work sites.
• If the trimmer head becomes jammed, stop the
engine immediately.
• Make certain all moving parts have stopped and
disconnect the spark plug before inspecting the
equipment for damage.
• Never use a String Trimmer that has chipped,
cracked or broken trimmer head.