Publicidad
Idiomas disponibles
Idiomas disponibles
Super Finish 21 Pro
6
HANDLING THE HIGH PRESSURE
HOSE
The unit is equipped with a high-pressure hose specially suit-
ed for diaphragm pumps.
Danger of injury through leaking high-
pressure hose. Replace any damaged high-
pressure hose immediately.
Never repair defective high-pressure hoses
yourself!
The high-pressure hose is to be handled with care. Avoid sharp
bends and folds: the smallest bending radius is about 20 cm.
Do not drive over the high-pressure hose. Protect against
sharp objects and edges.
Never pull on the high-pressure hose to move the device.
Make sure that the high-pressure hose cannot twist. This can
be avoided by using a Wagner spray gun with a swivel joint
and a hose system.
When using the high-pressure hose while
working on sca olding, it is best to always
guide the hose along the outside of the scaf-
folding.
The risk of damage rises with the age of the
high-pressure hose.
Wagner recommends replacing high-pres-
sure hoses after 6 years.
Only use WAGNER original-high-pressure
hoses with internal heating in order to ensure
functionality, safety and durability.
HANDLING THE HIGH-PRESSURE HOSE / INTERRUPTION OF WORK
7
INTERRUPTION OF WORK
1. Set pressure relief valve to
2. Switch the unit o using the ON/OFF switch (Pos. 0).
3. Pull trigger of the spray gun to decrease the pressure of
the high pressure hose and the spray gun.
3. Secure the spray gun, refer to the operating manual of the
spray gun.
4. Remove tip from tip holder and store the tip in a small ves-
sel with suitable cleaning agent.
5. Leave the suction system immersed in the coating mate-
rial or immerse it in the corresponding cleaning agent.
The suction lter and unit should not dry out.
6. Cover the material container in order to prevent the paint
from drying.
In using quick-drying or two-component
coating materials, do not fail to rinse unit
through with a suitable cleaning agent dur-
ing the processing period.
EN
(pressure relief, circulation).
39
Publicidad
