Descargar Imprimir esta página

Marshall JVM410H Manual De Instrucciones página 10

Ocultar thumbs Ver también para JVM410H:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

ENGLISH
Note: using any other type of footswitch rather
than the one supplied will have no effect and will
be ignored by the amp.
14. SPEAKER OUTPUTS
1/4" jack speaker outputs. They are labelled
according to the corresponding cabinet setups:
• 1 x 16 Ohm: connect a 16Ω speaker cab..
• 1 x 8 Ohm / 2 x 16 Ohm: connect a single 8Ω
guitar cabinet or two 16Ω cabinets.
• 1 x 4 Ohm / 2 x 8 Ohm: connect a single 4Ω
guitar cabinet or two 8Ω guitar cabinets.
Warning: although the amplifier has five
speaker outputs, never attempt to connect more
speakers than rated. The safe combinations are
listed above. Any other speaker configuration
may stress or damage the amp.
9
FOOTSWITCH
4 channel JVM amps are supplied with a
6-way programmable footswitch which can be
connected to the amp via any standard guitar
cable.
Warning: the supplied footswitch lead is
unscreened and not suitable for guitar.
The footswitch features 7 LEDS marked clean,
crunch, OD1, OD2, master, reverb and FX. The
LEDs for each of the 4 channels are 3-coloured
green, orange and red. These indicate which
channel and mode is selected, alongside the
status of master, reverb and FX loop.
Each of the individual footswitches has 2 modes
of operation:
• Switch store mode: Assign any of its 6
switches to instantly recall any front panel
function (channel/mode; reverb on/off;
master volume 1/2 and FX loop on/off).
Note: if a switch is assigned to select a
channel, once it has been activated it can be
used to scroll through the three modes, just
like its respective front panel switch.
• Preset store mode: Each switch can
be programmed to instantly call up a
combination of JVM button options to form
a preset. This allows you to recall complete
channel setups in any order and combination.
As the switches can be programmed
independently you can program a mixture of the
above.
Note: all the settings are stored within your
footswitch; this means it can be plugged into any
JVM amp and all your footswitch settings can be
instantly recalled.

Publicidad

loading

Este manual también es adecuado para:

Jvm410c