Marshall JVM410H Manual De Instrucciones página 5

switch will glow red.
6. A signal for recording is available through the
series/parallel FX loop send output jack and/
or the pre-amp out/send output jack.
Warning: always ensure a load is connected
before you switch the standby switch on (to
leave silent recording mode).
TRANSPORTING YOUR EQUIPMENT
Please ensure that your amp is switched off,
unplugged from the mains electricity supply and
all removable cables have been disconnected
from your equipment before attempting to move
it.
Only move the amp on its own; do not attempt to
move it while it is stacked on top of a cabinet or
other equipment.
FCC COMPLIANCE STATEMENT
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful
interferance, and
2. This device must accept any interferance
received, including interferance that may
cause undesired operation.
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable
protection against harmful interferance in a
residential installation.
This equipment generates, uses and can radiate
frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interferance to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interferance
to radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the seperation between the
equipment and the receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio /
TV technician for help.
CAUTION: Any changes or modifications not
expressly approved by the party responsible
for compliance may void the users authority to
operate the equipment.
This device complies with CAN ICES-3(B)/NMB-
3(B).
ENGLISH
4