Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance
Inner side
•
Inner surface: Clean the inner side of the door manually using a soapy plastic
scouring pad, and then wipe with a dry cloth. Take care not to get the gasket
wet or allow moisture into the door.
•
Inner glass: The inner glass is cleaned automatically during the self-cleaning
cycle.
Outer side
•
Outer surface: Follow the cleaning instructions for stainless steel surfaces in
the previous section.
•
Outer glass: Clean the outer glass using a glass cleanser or soapy water. Rinse
and dry thoroughly. Take care not to get the gasket wet or allow moisture into
the door.
*
Surface burners
Burner controls
Make sure all surface burner knobs are in the OFF position.
38 English
CAUTION
•
Do not let moisture enter the door or
contact the door gasket (*). Moisture
may reduce the gasket's performance.
•
Do not let moisture or water enter the
burners, electrical controls, or switches.
1.
Pull the knobs off the control valve
stems as shown.
2.
Clean the knobs in warm, soapy water.
Then, rinse and dry them thoroughly.
3.
Clean the stainless steel surfaces using
stainless steel cleaner.
4.
Push the knobs back onto the control
valve stems.
CAUTION
Do not clean the control knobs in a dish washer.
•
•
Do not spray cleansers directly onto the control panel. Moisture entering the
electric circuits may cause electric shock or product damage.
Cooktop surface
The porcelain-enameled cooktop surface needs to be kept clean. We recommend
that you remove food spills immediately after they take place.
CAUTION
•
Do not use a steel-wool pad or abrasive cleaner, which can scratch or damage
the enamel surface.
•
Do not remove the cooktop surface to clean it. The gas lines leading to the
burner manifolds can be damaged, resulting in a fire or system failure.
1.
Turn off all surface burners.
Wait until all burner grates cool down,
2.
and then remove them.
3.
Clean the cooktop surface using a soft
cloth. If food spills run into the gaps
of the burner components, remove the
burner cap and the head, and then wipe
up the spills.
4.
When cleaning is finished, re-install the
burner components, and then put the
burner grates into position.
Publicidad
