Publicidad
Idiomas disponibles
Idiomas disponibles
Burner grates and components
Turn off all surface burners, and make sure they have all cooled down.
2
1
3
8
7
6
Top
Bottom
1.
Remove the burner grates.
2.
Remove the burner caps from the
burner heads.
3.
Remove the burner heads from the
valve manifolds to reveal the starter
electrodes.
4.
Clean all removable grates and burner
components in warm, soapy water. Do
not use steel-wool pads or abrasive
cleaners.
Rinse and dry grates and burner
5.
components thoroughly.
6.
Return the burner heads to their
positions on top of the manifold
valves. Make sure a starter electrode
is inserted through the hole in each
burner head.
7.
Return the burner caps to their
positions on top of burner heads. To
ensure proper and safe operation, make
sure the burner caps lie flat on top of
the burner heads.
8.
Re-install the burner grates in their
respective positions.
Turn on each burner and check if it
9.
operates properly. After verifying that
a burner operates normally, turn it off.
NOTES
After cleaning, confirm that the burner port openings aren't plugged.
•
•
Shake out any excess water and then let burner heads and caps dry thoroughly.
Placing the center burner upside down will allow the water to drain out more
easily.
•
Do not wash any burner components in a dish washer.
CAUTION
•
The starter electrodes are not removable. Do not attempt to remove them by
force.
•
Make sure all burner components (heads and caps) are reinstalled properly.
When installed properly, they are stable and rest flat.
•
To avoid chipping, do not bang grates and caps against each other or hard
surfaces such as cast iron cookware.
Do not attempt to remove center oval burner cap from the head.
•
English 39
Publicidad
