Mafell K 85 Ec Traduccion Del Manual De Instrucciones Originale página 26

4 Setting / adjustment
4.1 Mains connection
Prior to commissioning make sure that the mains
voltage complies with the operating voltage stated on
the machine's rating plate.
4.2 Chip extraction
Danger
Substances that are harmful to
health must be taken up with an M-
suction device.
Connect the machine to a suitable external dust
extractor during all work generating a considerable
amount of dust. The air velocity must be at least 20 m/s
(65.6 ft / sec.).
The internal diameter of hose connector 3 (Fig. 1) is 35
mm ( 1 3/8 in.).
4.3 Saw blade selection
Use a sharp tool to obtain a good cut quality and select
a tool from the following list according to material and
application:
For cuts along and across the grain in soft or hard
wood:
- Circular saw blade carbide Ø 237 x 2.5 x 30 mm, 24
teeth
For cuts especially along the grain in soft or hard
wood:
- Circular saw blade carbide Ø 237 x 2.5 x 30 mm, 12
teeth
For cuts especially across the grain in soft or hard
wood:
- Circular saw blade carbide Ø 237 x 2.5 x 30 mm, 56
teeth
Cutting of wood fibre insulation materials:
- Circular saw blade carbide Ø 237 x 2.5 x 30 mm, 56
teeth
Cutting of synthetic materials (polystyrene):
- Circular saw blade carbide Ø 237 x 2.5 x 30 mm, 24
teeth
4.4 Saw blade change
• Press the push-button 2 (Fig. 2) and pull the locking
lever 19 upwards. Now the saw shaft is locked in
position and the gearshift lever locked. You can lock
the retractable saw guard in an open position with
the aid of the pre-feed lever 1 (Fig. 2) or manually
to make the tool change easier.
• Using the Allen key 5 (bracket Fig. 2), release the
flange screw 18 (Fig. 3) counter clockwise. Now
remove both the screw and the front clamping
flange 12.
• You can now remove the saw blade.
• The clamping flanges must be free of adhering
parts.
• Pay attention to the sense of rotation when inserting
the saw blade.
• Afterwards, push on the clamping flange, apply the
flange screw and tighten it by turning it clockwise.
• Close the retractable saw guard. To do so, press the
locking lever 19 (Fig. 2) downwards.
4.5 Riving knife/splitter
The riving knife / splitter 15 (Fig. 3) prevents the saw
blade from jamming during longitudinal cutting. The
correct distance to the saw blade is shown in (Fig. 4).
• For adjustment purposes, release the screw 4 (Fig.
3) with the Allen key 5 that is included in the supply
(Fig. 2)
• Adjust the riving knife/splitter by moving it in its
longitudinal groove and retighten the screw
afterwards.
-26-
Danger
Pull the power plug during all
service work.
Danger
Pull the power plug during all
service work.